I came across this beautiful pair of owls on Thingiverse that I just can't help wanting to print them. The models are too big for the Portabee and the author suggested scaling them down to fit. Not wanting to spend too much time printing as it was almost 11pm, I scaled of the pair down to 50% which gives a built time of about an hour.
As I've not done calibrating, the result isn't as good as the photos posted by others that did the same print. But I'm rather happy with what was produced except that I broke one of the thinner part of the brows while cleaning up the model.
I'll post the time lapse pics when I have the time. It's almost 1am in the morning.
As I've not done calibrating, the result isn't as good as the photos posted by others that did the same print. But I'm rather happy with what was produced except that I broke one of the thinner part of the brows while cleaning up the model.
I'll post the time lapse pics when I have the time. It's almost 1am in the morning.
RSS Feed
