Wongster's Production
Share it on
  • Home
  • Blog
  • My Old Blog
  • My Shop
  • Resources
  • About Me...
  • Contact Wongster

Broken Cover

23/5/2012

0 Comments

 
Picture
I had a surprise this morning when I saw the acrylic cover on the lathe broke from its swivel base. I don't remember breaking it during the last session as that will be pretty obvious looking at the way it is broken.

Anyway, there is a magnet at the swivel base that cut off power to the lathe when the cover is lifted up. It does gets in the way when turning big diameter stock close to the spindle but it prevent accidental touching of the spinning spindle when in operation.

I wonder if I should replace it or Loctite the magnet on the swivel base to allow the spindle to work without it. Those safety conscious folks may jump with it off but... I don't know. Will think about that.

0 Comments

Your comment will be posted after it is approved.


Leave a Reply.

    Enter your email address:

    Delivered by FeedBurner

    Categories

    All
    3d Printer
    Er32 Collet Chuck Proxxon
    Misc
    Misc Projects
    Projects
    Proxxon Pd400
    Sherline / A2Z Monster Mill
    Things I Bought
    Wabeco Mill

    Archives

    June 2018
    January 2017
    December 2016
    August 2015
    July 2015
    June 2014
    May 2014
    December 2013
    November 2013
    October 2013
    June 2013
    March 2013
    February 2013
    November 2012
    October 2012
    September 2012
    August 2012
    July 2012
    June 2012
    May 2012

    RSS Feed

Powered by Create your own unique website with customizable templates.